Reflectatherm Plus is a reflective, high resistance air and vapour control layer for internal walls, ceilings and floors, specifically designed to enhance the thermal performance when placed on the warm side of the insulation.

The membrane should be installed with the foil side facing the cavity. In ceilings the product is placed between the underside of the rafters and the ceiling lining. Adjacent sheets should be lapped by at least 150mm and sealed with a suitable tape. Minimise penetrations caused by services and seal all joints.

Key Features

• High vapour resistance
• Improved airtightness
• Creates service void
• Help meets the requirements of the Part L in England and Wales, Section 6 in Scotland, and Technical Guidance Document L in Ireland
• R value of 0.72 m2 K/W when used with a minimum 19mm service cavity
• Creates an unbroken vapour control layer
• Sd Value of >150m
  
  

Datasheets

Product Datasheet
Specification Performance
Installation Guide

The above information is based on current test data, health and safety information and application instructions supplied by our suppliers and manufacturers of the products. It is supplied for guidance and to the best of our knowledge is true and accurate. Customers should satisfy themselves to the suitability of the products in its intended use and no guarantee is given or implied as the conditions of actual use are beyond our control. If in doubt the customer should consult the designer of the project or the local building control. 

Fire Stopping Shop, disclaim any liability for loss, damage or other expense which may arise from the use of this information, data or products refereed to and reserve the right to amend or change any details without notice. This statement does not affect your statuary rights.